Binding the evotouch controller to the OPENTHERM-Bridge boiler 4.5
feedback
i
The following modules can be used for boiler feedback as well: BDR91, HC60NG, R6660D.
For the BIND buttons and checking RF communication of these modules see section 4.4.
Binding procedure4.5.1
Follow the guided or expert conguration until the f
following screen appears.
Press and hold the bind button (1) of the OPENTHERM- f
Bridge for 5 seconds to activate the bind mode.
Press the BIND button on the the f evotouch controller
to send the bind signal to the OPENTHERM-Bridge.
The red LED of the OPENTHERM-Bridge is switched
off to confirm a successful binding.
i
Binding is terminated automatically after 5 minutes.
To Next Page
Loading...
