Binding the evotouch controller to the DT92 room adjuster/sensor4.8
Binding procedure4.8.1
Follow the guided or expert conguration until the f
following screen appears.
Position the f evotouch controller as close as possible
to the DT92.
Press and hold both arrows up and down until the f
display changes.
Press button (1). f
Binding takes place automatically.
i
Press button (1) approx. 5 sec. when the display on
DT92 does not appear as pictures shows.
i
The binding mode remains active for max. 10 minutes
after the last button was pressed.
To Next Page
Loading...
