Honeywell Evohome

Application Manual 35
Binding the evotouch controller to the HM80 mixing valve controller 4.6
Binding procedure4.6.1
Follow the guided or expert conguration until the f
following screen appears.
Press both buttons (1) and (2) at the HM80 for approx. f
4 seconds until the LED (3) ashes regularly.
3
1
2
Position the f evotouch controller as close as possible
to the HM80 mixing valve controller.
Press the BIND button on the f evotouch controller
to send the bind signal to the HM80 mixing valve
controller.
The LED (3) of the HM80 is switched OFF to confirm a
successful binding.
i Binding is terminated automatically after 3 minutes.