Honeywell Evohome

Application Manual 37
Binding the evotouch controller to the HCE80(R) / HCC80(R) underoor 4.7
heating controller
i For zones 2 – 6 an external room sensor (DT92 / HCW82 / HCF82) must be bound to the evotouch controller.
Binding room sensor4.7.1
Follow the guided or expert conguration until the f
following screen appears.
Press and hold the installation button (1) at the f
underoor heating controller for approx. 2 seconds.
The LED of zone 1 flashes red.
1
3
2
Position the f evotouch controller as close as possible
to the underoor heating controller.
Press the BIND button on the f evotouch controller
to send the bind signal to the underoor heating
controller.
The LED of the selected one lights continuously red.
Press the BACK button on the f evotouch controller to
proceed with the binding of the room setpoint.