32 Network Graphic Annunciator (NGA) Operations Guide P/N 9020-0675:B1 03/21/13
I/O Screen I/O Screen (Device Tab) Options
8.6 I/O Screen (Device Tab) Options
Table 8.6.1 describes the options that appear on the I/O, Device tab screen.
I/O Screen
(Device Tab)
Controls
Description
LOOP Tap LOOP to enable a direct entry of a loop number (loop 1, loop 2 or
discrete devices). To select discrete devices, enter "0".
RANGE Tap RANGE to toggle between Sensors, Modules and Bases.
ADDRESS Tap ADDRESS to enable a direct entry of a device address.
SHIFT Press SHIFT to move the focus of the yellow highlight between Loop and
Address.
ENABLE/DISA
BLE
If this button reads "ON", it will manually activate this output device. If this
button reads
"AUTO", it will return the device to its normal automatic operation.
UP/DOWN Use the up and down arrow buttons to scroll to either the Loop or the
Address based on which control appears highlighted in yellow. Use the
SHIFT button to shift the focus.
X Press the "X" button in the upper right corner to close this screen.
Table 8.6.1 I/O Screen (Device Tab) Controls
To Next Page
Loading...
