Honeywell Gamewell-FCI NGA - History Log Management; Log Screen Entry Tab Functionality; Log Screen Entry Tab Options

Network Graphic Annunciator (NGA) Operations Guide P/N 9020-0675:B1 03/21/13 39
Section 11: Log Screen
11.1 Log Screen (Entry Tab)
The Log screen allows you to view events that are stored in the NGA's History Log. In addition, the
Log screen provides options for printing and clearing the History Log.
Figure 11.1.1 illustrates the
screen that appears when the user selects the Entry tab from the Log screen.
Figure 11.1.1 Log Screen (Entry Tab)
11.2 Log Screen (Entry Tab) Options
Table 11.2.1describes the buttons that appear on the Log Entry tab screen.
Log Screen
(Entry Tab)
Options
Description
Print All Prints a report of all events in the History Log via the NGA's serial port. See
the NGA Installation Instructions (P/N: 9000-0568) for the correct terminal
connections for the serial port.
Print last
20
Prints a report of the last twenty events stored in the History Log via the
NGA's serial port.
Clear Log Erases the Event History Log for all nodes in the system. Press this button
to open a confirmation window that will allow the user to either clear the
History Log or cancel the operation.
NOTE: Clearing the History Log will cause a hard reset on all INI-7100, ILI-E3/ILI95-E3 Series,
ANX and NGA nodes in the system.
UP / DOWN Use the up and down arrows to scroll the event display backward (down)
and forward (up).
X Press the "X" button in the upper right corner to close this window.
Table 11.2.1 Log Screen (Entry Tab) Buttons