Honeywell Gamewell-FCI NGA - View Screen Device Tab Options

38 Network Graphic Annunciator (NGA) Operations Guide P/N 9020-0675:B1 03/21/13
View Screen View Screen (Devices Tab) Options
10.6 View Screen (Devices Tab) Options
Table 10.6.1 describes the controls that appear on the View, Devices Tab screen. The following
types of information may be displayed for each SLC device:
• Device Type
• Verification: None, PAS or Verify
View Screen
(Devices Tab)
Options
Description
LOOP Tap LOOP to enable a direct entry of a loop number (loop 1 or
loop 2).
RANGE Tap RANGE to toggle between Sensors and Modules.
ADDRESS Tap ADDRESS to enable a direct entry of an SLC device
address.
SHIFT Press SHIFT to move the focus of the yellow highlight between
Loop and Address.
UP/DOWN Use the up and down arrow buttons to scroll to either the LOOP
or the ADRESS depending on which control appears highlighted
in yellow. Use the SHIFT button to shift the focus.
X Press the "X" button in the upper right corner to close this
screen.
Table 10.6.1 View Screen (Devices Tab) Controls
NOTE: Once a loop, range and address have been selected, the information about the device
will appear on the View Devices screen. If the selected address is not configured on the specified
node (or is an invalid address), the NGA displays a small pop-up error window indicating the error.