34
Honeywell 30 Series IP Cameras User Guide
Note:
If you enable Anti-overexposure, the effect of manual IR adjustment may be not
obvious.
Configuring Image Settings
Go to Setup Camera Setup Image Settings.
On this page, you can configure the white balance and adjust image parameters.
Two sets of image settings are available:
• In Normal Light Mode tab, configure normal situations for image settings.
• In Profile Mode tab, configure special situations for image settings.
Figure 41 Image Settings
White Balance
Adjust the value for the best color temperature.
Auto: Select it and the camera will automatically adjust the color temperature.
Fixed current: Select it and the camera will use current color temperature value.
Manual: You can manually tune the color temperature by dragging the R Gain and B
Gain slider.
Image Adjustment
Brightness: Adjust the image brightness level (0% to 100%).
Contrast: Adjust the image contrast level (0% to 100%).
Saturation: Adjust the image saturation level (0% to 100%).
Sharpness: Adjust the image sharpness level (0% to 100%).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
