Honeywell HF680 - Good Read Delay; User-Specified Good Read Delay; IR Trigger Mode

HF680 Series User Guide 33
Good Read Delay
This sets the minimum amount of time before the scanner can read another
barcode. Default = 0 ms (No Delay).
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the barcode below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the
Programming Chart, then scanning Save.
IR Trigger Mode
When in IR Trigger mode, the scanner uses an infrared (IR) sensor to detect objects
and start to scan and decode barcode symbols. Default = IR Trigger Mode.
* No Delay
Short Delay (500 ms)
Medium Delay (1,000 ms)
Long Delay (1,500 ms)
User-Specified Good Read Delay
IR Trigger Mode