Honeywell HF680 - Upc-A

86 HF680 Series User Guide
UPC-A
<Default All UPC-A Settings>
UPC-A On/Off
Note: To convert UPC-A barcodes to EAN-13, see Convert UPC-A to EAN-13 on page 92.
UPC-A Check Digit
This selection allows you to specify whether the check digit should be transmitted
at the end of the scanned data or not. Default = On.
UPC-A Number System
The numeric system digit of a U.P.C. symbol is normally transmitted at the
beginning of the scanned data, but the unit can be programmed so it will not
transmit it. Default = On.
* On
Off
* On
Off
* On