HF680 Series User Guide 75
select the code page with which the barcodes were created (see ISO 2022/ISO 646
Character Replacements on page 168), and scan the value and the Save barcode
from the Programming Chart. The data characters should then appear properly.
Interleaved 2 of 5
< Default All Interleaved 2 of 5 Settings >
Interleaved 2 of 5 On/Off
Check Digit
No Check Digit indicates that the scanner reads and transmits barcode data with
or without a check digit.
When Check Digit is set to Validate, but Don’t Transmit, the unit only reads
Interleaved 2 of 5 barcodes printed with a check digit, but will not transmit the
check digit with the scanned data.
When Check Digit is set to Validate and Transmit, the scanner only reads
Interleaved 2 of 5 barcodes printed with a check digit, and will transmit this digit at
the end of the scanned data. Default = No Check Digit.
To Next Page
Loading...
