Honeywell HRDP DVR - Action; Alarm Monitor

Setup
______________________________________________________________________________________________
48
Action
CH – S Channels 1~8 / T Channels 9~16
Alarm – OFF / 1~4 [Associate an alarm relay with a channel].
Delay – 0~100 Seconds [Delay time before relay activates].
Duration – 0~100 Seconds [Time that the relay is active].
Preset – 0~100 [Enable PTZ camera to move to a preset position when an
event occurs. See PTZ Control for more information.]
Event Popup – ON / OFF [Displays channel associated with event].
Alarm Monitor
Send event information to a remote client using the Alarm Monitor software.
1. Select Enable and press ENTER to select ON.
2. Enter the IP Address of the remote client.
3. Enter the Port Number.
INPUT SENSOR ACTION ALARM MONI TOR
ALARM
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
PRESET
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
CHT
1
2
3
4
5
6
7
8
DELAY
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
DURATION
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
EVENT POPUP OFF
9CH-16CH
INPUT SENSOR ACTION ALARM MONI TOR
IP ADDRESS
0 . 0 . 0 . 0
0 . 0 . 0 . 0
0 . 0 . 0 . 0
0 . 0 . 0 . 0
0 . 0 . 0 . 0
PORT
2001
2001
2001
2001
2001
NO.
1
2
3
4
5
SEND TO ALARM MONITOR ON