Honeywell HRDP DVR User Manual

Performance Series DVR User Guide
______________________________________________________________________________________________
Document 800-02089 Rev E 49
10/08
Network
Network Configuration
Configure network settings.
DHCP Select – System gets IP address from DHCP server.
Clear – User must manually define a static IP address. Contact the
network administrator for this information.
Host Name – The DVR name.
IP Address – DHCP or Static. Contact your network administrator for this
information.
DDNS Server – The current DDNS server.
ID – Username for the DDNS server account.
Password – Password for the DDNS server account.
Host Name – Hostname for the DDNS server account.
Router IP - When set to the ON state, Router IP reports your network’s external
IP address to the DDNS service. This is important if your router is running NAT
(Network Address Translation) services for your network.
If you are unsure of your network configuration Honeywell recommends this
feature be set to ON.
Status – Select Check to confirm the DDNS settings.
If Check returns SUCCESS, the settings are correct and DDNS is configured. If
Check returns FAIL, check to make sure the ID, PASSWORD and HOSTNAME
are correct, and then try again.
HOST NAME dvr
000.000.000.000
000.000.000.000
000.000.000.000
000.000.000.000
DDNS SERVER
ID
PASSWORD
HOST NAME
ROUTER IP
STATUS
HWddns.com
user
****
host
OFF
CHECK UNCHECKED
DHCP
IP ADDRESS
SUBNET MASK
GATEWAY
DNS
DDNS
NETWORK

Honeywell HRDP DVR Specifications

General

Brand	Honeywell
Model	HRDP DVR
Category	DVR
Language	English