There is a demanding or important guest that wants to be able to set Room Target temperature to a higher or
lower value than what is currently selectable on the e7w. ................................................................................... 25
Appendix 1: Setting the Room ID, PAN ID and RF Channel into the e7w during Initialization .............................. 26
Setting the Room ID during Initialization ........................................................................................................... 26
Setting the PAN ID during Initialization ............................................................................................................. 27
Setting the RF Channel during Initialization....................................................................................................... 28
Appendix 2: Reading or Setting the Room ID, PAN ID and RF Channel into the e7w after it has been Initialized 29
RID – Setting e7w Room ID (rld)......................................................................................................................... 29
PAN – Setting e7w PAn ID (PAn) ........................................................................................................................ 31
RF – Setting e7w RF Channel (rF) ....................................................................................................................... 31
Appendix 3: Using the e7w Ping Feature ............................................................................................................... 31
Appendix 4: Using the e7w Process Image Viewer ................................................................................................ 34
Appendix 5: Setting the e7w “PA” Partner Address ............................................................................................. 36
Appendix 6: Using the e7w bAu (Battery Level) Parameter ................................................................................ 37
Appendix 7: Using the e7w WAN Test .................................................................................................................. 38
Appendix 8 : Using the e7w PING Test.................................................................................................................. 39
Appendix 9 : Using the e7w CBL32 Registry Viewer/Editor .................................................................................. 41
Appendix 10: Using the e7w Door Test................................................................................................................. 45
Appendix 11: Adjusting the e7w PIR Motion Sensor Sensitivity .......................................................................... 47
To Next Page
Loading...
Need help?
General
