8. With the value of the defined Registry Offset now displayed, use the Up/Down arrow buttons to change the
value if desired. In order for any change to be permanent, you must press the FAN button to store the
change.
Upon pressing the FAN button to store the change, a Cloud / Sun icon will begin to blink in the upper left of
the display to indicate a change to the Registry of the HVAC partner device has been made.
9. If you desire to make additional changes to the current selected registry or other Registry’s:
a. Each press of the FC button returns to the previous Group:Key or Group:Key:Index level. Press the
FC button as many times as required to back out to the desired Group:Key or Group:Key:Index
For example, if currently viewing Registry 9:1 (Group 9:Key 1) Parameter 8 value:
b. When the desired level is reached, use the Up / Down arrow buttons to select the desired Group , Key or
Index value , then press the MODE button to view the value of the selected Group , Key or Index value.
10. If no further changes are desired, press the FC button as many times as required to back out through the
Gr9 menus until Str (Store) is displayed. Pressing the FAN button again with Str displayed will Commit the
registry and permanently store all changes.
The e7w will RESET in order to store the changes and exit out of Parameter mode.
To Next Page
Loading...
Need help?
General
