Honeywell INTELLIGUARD 9000 - Arm an Area with a Code

12
ARMING
2. Arm an Area with a Code
ACTION MESSAGE SIGNAL
Press
AREA ? –
Enter the AREA # to arm. ID ? – –
Enter your ID #. ID ? # #
CODE ? – – – – 2 BEEPS
Enter your CODE #.
1—SYSTEM TEST 2 BEEPS
NOTE 1: If a device is at fault, the control center displays the fault.
Consult the “REFERENCE GUIDE” section for a description of the message.
If the user is able to correct the source of the fault, the arming procedure
resumes. If the fault is not corrected, the user may decide to force arm the
AREA by acknowledging the fault—if this option was enabled. Refer to the
“FORCE ARMING” section.
The system records which user has force armed the AREA.
REQUEST ACCEPTED
AREA 1 ARMED ACKNOWLEDGE
TONE THEN EXIT
DELAY BEEP TONE
STARTS
NOW EXIT THE PREMISES