Honeywell INTELLIGUARD 9000 - Testing all Detectors

20
2. Testing all Detectors
TESTING
ACTION MESSAGE SIGNAL
Press
ID ? –
Enter your ID #. ID ? # #
CODE ? – – – –
Enter your CODE #. TEST MENU
HOLD UP TEST
NOTE 1: The walk test can be performed by a user with authority level (one) at any time the area
is disarmed. After completion of the test the event log can be viewed. Any detector
causing an alarm during the test will show in lower characters.
Press until you reach
TEST MENU
WALK-TEST
WALK-TEST
To accept WALK-TEST
press
AREA ? –
Enter the AREA #
for which you want
WALK-TEST
the testing
NOTE 2: Now walk the protected area in front of all motion sensors, open doors and protected
windows. Each time a sensor alarms, 2 beeps are heard. At the end of the test;
Press
END TEST
To exit press
TEST MENU
WALK-TEST
** INTELLIGUARD 9000 **
yy/mm/dd hh:mm
TEST
TESTING