25
5. View System Events
ACTION MESSAGE SIGNAL
Press
ID ? – –
Enter your ID #. ID ? # #
CODE ? – – – –
Enter your CODE #. MODE MENU 2 BEEPS
1—SYSTEM STATUS
Press until you reach:
EVENT LOG
MENU MODE
3—EVENT LOG
To accept
EVENT LOG
press
A1 DISARM ID02 …
yy/mm/dd hh:mm
If three dots follow the description of the event log, you may
view additional information on the event log by pressing
NOTE 1: EXAMPLE ONLY
“A1 DISARM ID02…”indicates that AREA # 1 has been disarmed by user # 2, more
information is included. Consult the “REFERENCE GUIDE” section for a description
of the message.
— The detectors activation date and time are in UPPER CASE characters.
— The detectors reset date and time are in LOWER CASE characters.
“yy/mm/dd hh:mm “ indicates the date and time of the event.
To view previous
events, press
END OF LIST! 2 BEEPS
(2 sec)
NOTE 2: A new event is displayed every time the DOWN ARROW key is pressed. “END OF
LIST!” indicates the last event.
To exit , press
MODE MENU
3—EVENT LOG
To exit, press
** INTELLIGUARD 9000 **
yy/mm/dd hh:mm
?
MODE
To Next Page
Loading...
