1-96
Rev 2 Apr/2004
KMD 250 Pilot's Guide
Section 1
Basic Operation
INSERTING A NEW
DATACARD
Each KMD 250 Database cycle
will result in the necessity to
load a new database when
using the database subscripti-
on service. This is done by
inserting a new datacard.
NOTE: Since all user way-
points and flight plans are
stored on the datacard, it will
be necessary to transfer this
data to the new datacard.
The following displays depict
those seen on a KMD 250 con-
taining the internal GPS.
To change the datacard follow
these steps:
1. Turn off the KMD 250.
2. Push in the datacard until it
clicks, then release. The data-
card should now slide straight
out.
3. With the new card facing
upward, as indicated on it’s
label, insert the new datacard
until it clicks. The new data-
card is now locked in place.
4. Turn the unit on and, if
necessary, wait for the new
software to load.
5. Figure 1-183 will be dis-
played to allow flight plans and
waypoints stored on the previous datacard to be moved to the new data-
card. Press the YES Softkey to move stored data. Other wise press the
NO Softkey.
6. After pressing the YES Softkey, Figure 1-184 will be displayed. As
directed, remove the new datacard and re-insert the old datacard.
7. When Figure 1-185 is displayed re-insert the new datacard.
Datacards
Figure 1-183
Figure 1-184
Figure 1-185
To Next Page
Loading...
