EasyManua.ls Logo

Honeywell KMD 250 - Setting up a VDL Subscription

Honeywell KMD 250
274 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2-23
SETTING UP A FIS VDL SUBSCRIPTION
At least one subscription must be set up, even to receive the no-charge
services. Up to four different concurrent subscriptions can be set up
depending on the service packages desired.
NOTE: Entering more than four subscriptions will cause previous sub-
scriptions to be overwritten.
NOTE: The following details require selection of a KDR-510 as the
source for datalink weather data.
To set up a subscription, per-
form the following steps:
1. Press the MENU Key to dis-
play the AUX MENU Softkey
as shown in Figure 2-11.
2. Press the AUX MENU
Softkey to display the AUX-
MAIN MENU Page as shown in
Figure 2-12.
3. Turn the Rotary Knob or
move the Joystick to move the
cursor to select FIS
Subscription as shown in
Figure 2-12.
4. Press the SELECT Softkey
to display the AUX-FIS SUB-
SCRIPTION Page as shown in
Figure 2-13. On initial sub-
scription setup the subscription
window will show only blank
spaces as shown in Figure 2-
13, unless services were pre-
provisioned at the factory. In
this case some lines may not
be blank. If adding another
subscription, one or more pre-
vious subscriptions may be dis-
played with the associated
validity period and status.
The unique identifier for the
individual KMD 250 is dis-
played in the FIS DISPLAY ID
window. The unique ID shown
here is 0H100 11KSH.
KMD 250 Pilot's Guide
Section 2
FIS Operation
Rev 4 Aug/2007
FIS Subscriptions
Figure 2-11
Figure 2-12
Figure 2-13
KMD 250 FIS_R4 8/13/07 10:07 AM Page 2-23

Table of Contents

Related product manuals