Rev 2 Apr/2004 KMD 250 Pilot’s Guide
3-17
Section 3
Traffic Avoidance
TIS SYSTEM FAULTS
SYSTEM OFF
If the TIS system is set to the
OFF position, Figure 3-22 will
be displayed.
NO DATA RECEIVED
If the KMD 250 is not receiving
data from the TIS receiver then
Figure 3-23 will be displayed.
This could indicate that power
is not being provided to the TIS
receiver (e.g. a pulled breaker),
the TIS receiver is turned off, a
bad wiring connection between
the display and the receiver, or
a failed TIS receiver.
TRANSPONDER NOT
REPORTING ALTITUDE
If the transponder’s altitude
source has failed or the
transponder is put into a non-
altitude reporting mode, Figure
3-24 will be displayed.
Traffic Information Service
Figure 3-22
Figure 3-23
Figure 3-24
To Next Page
Loading...
