Honeywell KMD 250 - Retrieve User Data from Another Datacard

1-98
Rev 2 Apr/2004
KMD 250 Pilot's Guide
Section 1
Basic Operation
6. When Figure 1-189 is dis-
played, insert the datacard to
which the data will be copied.
7. After the datacard is
inserted, the data will be copied
and Figure 1-190 will displayed
indicating the data was copied
successfully.
8. Re-insert the original data-
card.
NOTE: In units that do not con-
tain the internal GPS, refer-
ences to flight plans will not be
displayed. For example the
title of the window in Figure 1-
190 will be “USER WAYPOINT
DATA STORED”.
RETRIEVE USER DATA
FROM ANOTHER DATA-
CARD
To move from one datacard to
another, perform the following
steps:
1. Press the MENU Key.
2. Press the AUX MENU
Softkey to display Figure 1-
191. Use the Joystick to high-
light User FPL Save/Load as
shown.
Datacards
Figure 1-189
Figure 1-190
Figure 1-191