4-3
Rev 2 Apr/2004 KMD 250 Pilot's Guide
Section 4
Stormscope®
SWITCH BETWEEN WEATHER VIEWS
When the Stormscope® display is selected the KMD 250 can display
strikes in one of two views, either all round (360°) or forward looking only
(120°). To switch the display turn the Rotary Knob to toggle between the
displays. Figure 4-1 is an example of the all round view and Figure 4-2
shows the forward looking view.
SWITCH BETWEEN DISPLAY MODES
The KMD 250 can display the
Stormscope® data in one of
two modes, either Cell Mode or
Strike Mode. To switch the dis-
play between modes press the
MENU Key to display Figure 4-
3. Press the CHANGE MODE
Softkey to toggle between
CELL MODE and STRIKE
MODE as shown in Figure 4-4.
The mode selected here will
remain in effect until you
change it, unless the unit is
turned off and back on.
Cell Display Mode
When viewing the
Stormscope® display, if cell
display mode is selected, the
KMD 250 plots a "+" symbol
(discharge point) on the display
when it detects associated dis-
charges within the selected
range and view (see Figure 4-
Stormscope® Operation
Figure 4-1
Figure 4-2
Figure 4-3
Figure 4-4
To Next Page
Loading...
