Honeywell KMD 250 - Deleting a Direct-To Within the Active Flight Plan

1-74
Rev 2 Apr/2004
KMD 250 Pilot's Guide
Section 1
Basic Operation
DELETING A DIRECT-TO
WITHIN THE ACTIVE
FLIGHT PLAN
If it becomes necessary to
delete a Direct-To in an active
flight plan (as seen in Figure 1-
140), perform the following
steps:
1. Press the Direct-To Key to
display Figure 1-144.
2. Press the DELETE
DIRECT Softkey to display
Figure 1-145.
3. Press the OK Softkey.
The Map will again be dis-
played with guidance to inter-
cept and resume the active
flight plan as shown in Figure
1-146.
Flight Plan Operation
Figure 1-145
Figure 1-146
Figure 1-144