Honeywell KMD 250 - Editing a User Waypoint

1-52
Rev 2 Apr/2004
KMD 250 Pilot's Guide
Section 1
Basic Operation
EDITING A USER WAY-
POINT
Editing a waypoint is accom-
plished in a similar manner to
entering a new waypoint. To
edit a User Waypoint that has
been previously stored, per-
form the following steps:
1. Press the MENU Key to
display Figure 1-91. Press the
AUX MENU Softkey to display
Figure 1-92. Use the Joystick
or Rotary Knob to place the
cursor over User Waypoints
as seen in Figure 1-92.
2. Press the SELECT
Softkey to display the USER
WAYPOINT LIST display as
shown in Figure 1-93. Use the
Rotary Knob and Joystick to
select waypoint to edit.
3. Press the EDIT WPT
Softkey to display the USER
WAYPOINT EDIT.
4. Repeat steps 3 through 20
in Entering A User Waypoint.
User Waypoints
Figure 1-93
Figure 1-91
Figure 1-92