Honeywell KMD 250 - Inserting a Waypoint in the Flight Plan

1-67
Rev 2 Apr/2004 KMD 250 Pilot's Guide
Section 1
Basic Operation
INSERTING A WAYPOINT IN
THE FLIGHT PLAN
To insert a waypoint in the flight
plan, perform the following
steps.
1. Use the Joystick to select
a waypoint in list to which the
new waypoint will be inserted
before or after (in this case
OTM) as shown in Figure 1-
124.
2. Select the new waypoint
with one of the following
methods.
To enter an identifier, turn the
Rotary Knob and the WAYPO-
INT ENTRY window will be dis-
played as in Figure 1-125. Use
the Rotary Knob to enter the
desired waypoint (KTVK) in the
same manner as discussed in
previous procedures. Press
the OK Softkey and the way-
point is entered before OTM as
shown in Figure 1-126.
Flight Plan Operation
Figure 1-124
Figure 1-125
Figure 1-126