Honeywell Lyric - Arming and Disarming the System

Lyric Controller Programming Guide
Program Zones (Continued)
Programming Field
Function and Action
Serial Number
(Continued)
3. The system beeps one time and returns to the Zone Programming Screen and
displays the programmed Serial Number and Service. Select “Save”.
4. The system returns to the Zone Programming Screen and the device’s battery
level and signal strength is displayed on the Lyric control. Activate the device to
confirm the enrollment.
NOTE:
If a duplicate serial number is entered, the system will emit a single long beep and
a confirmation screen will be displayed. Select “OK”. The system returns to the previous
screen.
Enroll 5800 Series Devices
The transmitter serial number and loop number can be enrolled via RF transmission
OR manually.
Enroll via RF Learning
To enroll the 5800 device using RF Learning mode, three transmissions (open/close)
of the device will be required. The initial transmission activates the RF Learning mode
and the system will emit a single beep. A second transmission enrolls the serial number
(which is displayed on the screen) and the system beeps two times and displays
“Activate Sensor Again To Confirm”. A third transmission will confirm the serial
number. The system beeps two times and returns to the Zone programming screen.
Select “Save”. The system returns to the Zone programming screen.
Enroll 5800 Devices Manually
1. Select the “RF Type” and scroll through the available device types until 5800 is
displayed.
2. Enter the 7-digit serial number printed on the transmitter using the displayed
keypad and select “Done”. The system beeps one time and returns to the Zone
Programming Screen.
3. Select “Save”. The system returns to the Zone Programming Screen.
NOTE:
If a duplicate serial number is entered, the system will emit a single long beep and a
confirmation screen will be displayed. Select “OK”. The system returns to the
previous screen.
Loop Number
NOTE:
This field does not apply to Hardwire Zone 1 and 2 or Temperature Zones (280-291)
or if SiX™ Series devices are being programmed.
Select “Loop Number” to toggle between 1, 2, 3 and 4 as applicable. Select Save.
Service
NOTE:
This field applies if SiX™ Series devices are being programmed.
Select “Service” to change the option, which is dependent on the type of SiX™ device
that is being installed.
Zone Description1/
Zone Description 2
Select “Zone Description 1 or Zone Description 2”. Using the displayed keypad enter
Zone Description 1 or Zone Description 2. The system announces the Zone Description.
Select “Done”, when you are finished. The system returns to the Zone Programming
page.
NOTE:
When programming the Zone Description, after entering the first letter of the
description on the keypad, use the up “˄” and down “˅” arrows to scroll through the
available preprogrammed zone descriptions.
Device Type
Use the down “
˅
”
arrow to scroll to the next page of options. Use the “
˄
” arrow to
return to the previous page.
Select “Device Type” from the displayed list, the system returns to the Zone screen.
Select “Save” if programming is complete.
Options:
New
Door
Window
Motion Sensor
Glass Break
Smoke Detector
Heat Sensor
Carbon Mono. Det.
Temperature
Flood
Environmental
Medical
Fire
Police
Local Alarm
Other
Garage Door
- 13 -