MA-2000
42 M-167.1-MA2000-EN / 06.2022
The following information applies to all spare parts listed in this documentation:
11.1 Preparation
1. Disconnect the control panel completely from the mains voltage!
2. Switch off the fuse (main power).
3. Remove the 2 screws and open the panel door.
4. Unplug the battery cable from the batteries.
5. Wait 1 minute to ensure that the panel is not energized before proceeding.
6. Unplug the battery cable from the board .
7. Unplug the main power supply connector from the board .
8. Remove the battery probe from the board .
For more information on spare parts, refer to the following chapters.
To Next Page
Loading...
Need help?
General
