ZX Fire Alarm Control Panels MORLEY-IAS
Commissioning Manual Document No. 996-175-000-1, Revision 01 Page 5
3 Controls and Displays
3.1 Control keys
• The control panel has two groups of control keys.
• A bank of five keys contains the four system control keys: Sound Alarms, Silence / Resound, Mute,
Accept and System Reset.
• A bank of 17 keys contains interactive and alphanumeric keys.
0
3
6
9>
N
Q
T
W
P
S
V
Y
Z
O
R
U
X
D
H
K
G
J
B
1
4
7
E
C
2
5
8
F
I
L
M
<
1 2 3 4 5 6 7 8 9 1011121314151617 181920
0
3
6
9>
N
Q
T
W
P
S
V
Y
Z
O
R
U
X
D
H
K
G
J
B
1
4
7
E
C
2
5
8
F
I
L
M
<
1
21
41
61
2
22
42
62
3
23
43
63
4
24
44
64
5
25
45
65
6
26
46
66
7
27
47
67
8
28
48
68
9
29
49
69
10
30
50
70
11
31
51
71
12
32
52
72
13
33
53
73
14
34
54
74
15
35
55
75
16
36
56
76
17
37
57
77
18
38
58
78
19
39
59
79
20
40
60
80
Figure 1 – ZX1Se /ZX2Se Controls and Displays Figure 2 – ZX5Se & ZX10Se Controls and Displays
Key Legend Symbol Function
Sound Alarms
Press to Turn on ALL Sounder Outputs (i.e. evacuate building
manually). NB: This will only function where EVAC (Evacuate
Enable) is Enabled in the Setup menu. The default state of EVAC is
Evacuate Enabled. If it has been disabled in a prior commissioning,
pressing this key will have no effect.
Silence /
Resound
Press to Turn off all activated sounders.
Press again to re-activate the sounders.
Mute Buzzer
Press to silence the internal buzzer.
Accept
Press to accept a Stage 1 Investigation Delay Alarm
System Reset
Press to cancel all alarm conditions and reset the panel.
Table 1 – Control Key Functions
• The alphanumeric keys normally function as a numeric keypad. During programming, these keys can
be toggled to Letter Keys by pressing the CHANGE key. This gives access to letters A-M. For access
to letters N-Z, press and hold the SHIFT key while pressing the appropriate letter key.
Alphanumeric Display
System Status LED
Display
Control Keys
Zone LED Display
Program / Interactive
Keys
Optional Zone LED
Display
To Next Page
Loading...
