Honeywell MultiRAE Series - Wireless Network Join and Interval Settings

Join Network
You can tell the MultiRAE to automatically join a network with a certain PAN ID without having
to specify the communications channel. The PAN ID is shown for reference (if it is incorrect, you
can change it in Safety Suite Device Configurator (SSDC)). Press [Y/+] to join. Note: If Roaming
is turned on, instead of a PAN ID number, you see “- - -”.
While it is searching for a network to join, the display shows this message:
Joining Network, Please Wait
If it is unsuccessful, you will see this message:
Failed To Join Network
Check your other settings, as well as those of the network you are trying to join.
You can press [Y/+] to retry or [N/-] to quit.
Interval
This menu allows you to change the interval between wireless transmissions. The interval can
be set to 10, 30, 60, 120, or 240 seconds.
1. Scroll down the list of intervals by pressing [N/-] until the interval you want is
highlighted.
2. Select the highlighted interval by pressing [Y/+].
3. Save or register the change:
l
Press [Y/+] to save the change.
l
Press [N/-] to undo the change.
Honeywell MultiRAE Series™ 104 User Manual