Honeywell NOTIFIER BACNET-GW-3 User Manual

13BACNET-GW-3 Installation and Operation Manual – P/N LS10014-000NF-E:C6 5/5/2017
Section 2 Installation
2.1 Required Equipment
BACNET-GW-3 Assembly:
The following components are shipped with the BACNET-GW-3:
• BACNET-GW-3 Printed Circuit Board
• Surge suppressor (P/N PNET-1)
• NUP-to-NUP Cable (P/N 75577) - Used to connect the BACNET-GW-3 board to an NCM-W or
NCM-F board or supported panel.
• Wire Leads-to-NUP Cable (P/N 75583) - Used to connect 24V power from the BACNET-GW-3
board to an NCM-W or NCM-F board.
• USB Cable (P/N 75665) - Used to connect the BACNET-GW-3 board to an HS-NCM board:
Network Components:
• High-speed Network Communication Module (HS-NCM) - Used to facilitate network
communication between the BACNET-GW-3 and a high-speed NFN network (sold separately).
OR
• Network Communication Module (NCM) - Used to facilitate network communication between the
BACNET-GW-3 and an NFN network (sold separately).
OR
• Compatible FACP with NUP port.
Customer Supplied Equipment:
• Computer - Used to run a web browser to configure the BACNET-GW-3. Refer to 1.4, "Required
Software" for recommended browsers.
• Ethernet Patch Cable - Used for connecting the BACNET-GW-3 to the Local Area Network (LAN).
– HS-NCM-W – HS-NCM-MF
– HS-NCM-WMF – HS-NCM-SF
– HS-NCM-WSF – HS-NCM-MFSF

Honeywell NOTIFIER BACNET-GW-3 Specifications

General

Brand	Honeywell
Model	NOTIFIER BACNET-GW-3
Category	Gateway
Language	English