ID3000 Series Installation & Commissioning Manual
Contents
iii 997-274-000-6, Issue 6
September 2009
4 Sensors and Modules 18
4.1 EN54 Requirements 18
4.1.1 Loop Devices - Sensors and MCPs 18
4.1.2 Loop Devices - Isolators 18
4.2 Loop Wiring Testing 18
5 Panel Electronics Modules 19
5.1 Introduction 19
5.2 Kit PSU3A 20
5.2.1 Procedure 20
5.3 Dual Transmission Path/Booster Module 23
5.3.1 Procedure 23
5.4 Main Chassis 25
5.4.1 Main Chassis Configurations 25
5.4.2 Procedure 25
5.5 Zonal LED & Printer Options 26
5.5.1 64 Zone LED Extension Chassis 26
5.5.2 PRN-ID Printer 27
5.5.3 LEDs for up to 256 Zones 29
5.6 Display PCB 31
5.7 Base PCB 32
5.7.1 Fitting the Replacement Base PCB 33
5.7.2 Cables and Wiring 33
5.8 Processor PCB 34
5.9 Loop Interface PCB 35
5.9.1 Cables and Wiring 35
5.10 Enhanced Loop Interface PCB 36
5.10.1 Cables and Wiring 37
5.11 Isolated RS232 Interface PCB 38
5.11.1 Cables and Wiring 39
5.12 Isolated RS485 Interface PCB 40
5.12.1 Cables and Wiring 40
5.13 Label Inserts 41
6 Repeaters and Master/Slave Network 42
6.1 Connecting Repeaters 42
6.2 Master/Slave Network Connections 43
7 Commissioning 44
7.1 Introduction 44
7.2 Preliminary Checks 44
To Next Page
Loading...
Need help?
General
