ID3000/ID2000 Fire Panel Configuration Tool Manual
Introduction
1 - 15 997-291, Version 3.05
November 2010
Receive Configuration from Panel
This allows you to copy the panel’s
configuration into the selected database.
1 Enter the panel’s access level 3 passcode.
2 Click OK. The Receive Configuration from
Panel window is displayed. For a short time
it is possible to abort (via the Cancel
Transaction button, which becomes greyed
when the data transfer commences).
Progress is shown by the bar and by
‘Transaction Status’ messages. When the
data transfer is complete, the panel’s
configuration is displayed automatically.
Note: If the data communications cable is
connected and the Communication Port
is correct yet you get an error message,
click OK and try again - the panel was
probably busy.
1
2
If the Tool ‘hangs’ during a
‘Receive’, check that the
correct Communication
Port has been selected.
To Next Page
Loading...
Need help?
General
