ID3000/ID2000 Fire Panel Configuration Tool Manual
Introduction
1 - 17 997-291, Version 3.05
November 2010
If the configuration has mixed protocol on
at least one loop and one or more VIEW
devices are located within address range
76-99, a message is displayed to advise
that there is a possible configuration
limitation unless the correct CPU PCB is
fitted (see Section 1.5.4).
Note: If the data communications cable is
connected and the Communication Port
is correct yet you get an error message,
click OK and try again - the panel was
probably busy.
If the Tool ‘hangs’ during a
‘Send’, check that the
correct Communication
Port has been selected.
To Next Page
Loading...
