17NFN Gateway Installation & Operation Manual - P/N: 52306:Rev: D 06/01/07
Section 2 NFN Gateway Embedded Installation
2.1 Required Equipment
The NFN Gateway requires the following:
NFN Gateway Assembly
The following are shipped with the NFN Gateway:
• NFN Gateway PC board (P/N 46173).
• Power supply (P/N 46175) - used for supplying +24VDC to +5VDC to the NFN Gateway PC
board.
• NFN Gateway/Power Supply Mounting Plate (P/N 18541).
• HDD Power connector (P/N 75581) - used for supplying +24VDC to +5VDC to the NFN
Gateway PC board.
• PNET-1 surge suppressor (P/N PNET-1).
• RJ45 to RJ45 standard Ethernet network cable (P/N 75585) - used to connect the NFN
Gateway PC board to PNET-1 surge suppressor.
• DB9 to NUP Cable (P/N 75554) - used to connect the NFN Gateway PC board to an NCM-
W/F board.
• NUP to +24VDC power cable (P/N 75583) - used for supply power to the NCM-W/F board.
• NFN Config Tool.
Network Components
• RJ45 to RJ45 standard Ethernet network cable - customer’s internet or intranet connection to
PNET-1 surge suppressor (supplied by customer).
• ONYXWorks
®
Workstation (v3.0 or above) or FIRSTVISION™ (v1.4 or above) (sold
separately).
• NFN network - version 5.0 or above (sold separately).
• Network Communication Module: NCM-W/F board - used to facilitate network
communication between the NFN Gateway and NFN network (sold separately).
Cabinet and Hardware (sold separately)
• CAB-3/CAB-4 series cabinet.
• CHS-4L chassis.
Customer Supplied Equipment
• PC to NFN Gateway Ethernet cross over cable - direct connection of the NFN Gateway to a
Configuration PC (refer to “Direct Connection to the Gateway PC Board” on page 31).
• PC - the NFN Configuration Tool installed on it to configure the NFN Gateway.
To Next Page
Loading...
Need help?
General