18 PM45 and PM45c User Guide
3. Load the media roll onto the media supply hub.
Note: Make sure you push the roll all the way against the inner wall of the printer.
4. Route the media through the print mechanism.
5. Adjust the media and dancer guides to hold the media in place. Adjust the
printhead balance.
6. Adjust the label gap and black mark sensor by turning the sensor adjustment
knob. The sensor blue LED should line up with the center of the media.
7. Turn the printhead lift lever clockwise to close the printhead.
8. The media is automatically advanced once you lock the printhead in place.
To Next Page
Loading...
