PM45 and PM45c User Guide 25
Load Ribbon
1. Open the media cover.
2. Turn the printhead lift lever counterclockwise to raise the printhead.
3. Slide the ribbon roll onto the ribbon supply hub.
Note: For ribbon that has the ink wound out, place the ribbon on the ribbon supply hub with
the ribbon wound clockwise. For ribbon that has the ink wound in, place the ribbon on
the ribbon supply hub with the ribbon wound counterclockwise.
4. Route the ribbon through the print mechanism and pull out approximately 8
inches (20cm) of ribbon leader.
= Ink out
= Ink in
To Next Page
Loading...
