Honeywell PM45 - System Alerts; Error

PM45 and PM45c User Guide 87
System Alerts
System alerts include error and warning.
Error
To view these settings:
• From the printer Main Menu, select Settings> Alerts > Error.
• From the printer web page, click Configure > Alerts > Error.
Ribbon Low Diameter Sets the minimum diameter of the ribbon roll before the
Ribbon Low alert is sent, if this alert is configured. Range is 0
to 200 mm.
0
Maintenance
Alerts Setting
Description Default
Alert Description
Status Determines if an alert is sent out for a specific error.
Delay Repeats Sets how often the alert is sent out for a specific printer event. Range is 1 to
65535.
Delay Unit Selects the unit of measure that determines how often the alert is sent out.
Message Sets the message that is sent out with alert for a specific printer event.
Errors Alerts
Default Values
Status
Delay Repeat Delay Unit Message
Next Label Not found Disable 1 Occurrences Error-Next label not found
Out of Media Enable 1 Occurrences Error-Out of media
Out of Ribbon Enable 1 Occurrences Error-Out of ribbon
Printer in Pause
Mode
Disable 1 Occurrences Error-Printer in pause mode
Printer in Menu Mode Disable 1 Occurrences Error-Printer in menu mode
Application Break Disable 1 Occurrences Error-Application break
RFID Not Installed Disable 1 Occurrences Error-RFID not installed
No RFID Tag Found Disable 1 Occurrences Error-No RFID tag found
Printhead Lifted Enable 1 Occurrences Error-Printhead lifted
Printhead Not
Detected
Disable 1 Occurrences Error-Printhead not
detected
Printhead Too Hot Disable 1 Occurrences Error-Printhead too hot
Motor Too Hot Disable 1 Occurrences Error-Motor too hot
Power Supply Too
Hot
Disable 1 Occurrences Error-Power supply too hot