20 PM45 and PM45c User Guide
Load Media for Label Dispenser
The label dispenser accessory which includes the label taken sensor removes the
liner from self-adhesive labels from the liner. The label taken sensor causes the
printer to wait for you to remove a label before printing the next one.
1. Open the media cover.
2. Turn the printhead lift lever counterclockwise to raise the printhead.
3. Pull down the label dispenser lever to open the media path.
4. Load a media roll onto the media supply hub. Adjust the edge guide and
dancer guide to hold the media in place.
Note: Make sure you push the roll all the way against the inner wall of the printer.
To Next Page
Loading...
