Honeywell
10
73024521a © Elster GmbH | All rights reserved. Subject to modification
1.1 Intended use
Responsibility for the use of the meter in terms of suitability,
intended use and the corrosion resistance of the materials to the
medium is solely in the hands of the operator.
The manufacturer shall not be liable for damage caused by
improper or inappropriate use.
1.2 Approvals and certifications
CE marking / EU declaration of conformity
The manufacturer certifies conformity with the EU
declaration of conformity and by attaching the CE marking.
The measuring instrument meets the statutory
requirements of the relevant EU Directives.
Comprehensive information on the applicable EU
Directives and Standards, as well as recognized
certifications, is contained in the EU declaration of
conformity.
The EU declaration of conformity is included in the delivery
and is also available to download at www.docuthek.com.
See chapter 5.3 Approvals and Annex A –
Standards and Norms, for details of other
approvals and Directives.
ATEX/IECEx
The turbine gas meters and quantometers are suitable for use
in Zone 1 hazardous areas and are approved with the following
certification (IECEx) and manufacturer’s declaration (ATEX):
IECEx TUR 16.0043x (IECEx)
203104000-0411 (ATEX)
TÜV Rheinland Industrieservice GmbH
Am Grauen Stein | 51105 Köln | Germany
DEKRA Certification B.V.
Meander 1051 | 6825 MJ Arnheim | The
Netherlands
To Next Page
Loading...
Need help?
General
