Solaris 7980g User Guide 93
Codabar Start/Stop Characters
Start/Stop characters identify the leading and trailing ends of the bar code. You
may either transmit, or not transmit Start/Stop characters. Default = Don’t Trans-
mit.
Codabar Check Character
Codabar check characters are created using different “modulos.” You can program
the scanner to read only Codabar bar codes with Modulo 16 check characters.
Default = No Check Character.
No Check Character indicates that the scanner reads and transmits bar code data
with or without a check character.
When Check Character is set to Validate and Transmit, the scanner will only read
Codabar bar codes printed with a check character, and will transmit this character
at the end of the scanned data.
When Check Character is set to Validate, but Don’t Transmit, the unit will only
read Codabar bar codes printed with a check character, but will not transmit the
check character with the scanned data.
Validate Modulo 16, but
Don’t Transmit
To Next Page
Loading...
Need help?
General
Weight and Dimensions
