Honeywell Solaris 7980g

Solaris 7980g User Guide 7
1. Remove the back cover and feed the interface cable through to the device.
2. Slide the back cover on and screw the back cover to the device, and then
connect the interface cable to the computer.
3. Turn the terminal/computer power back on. The scanner beeps.
4. Verify the scanner operation by scanning a bar code from the Sample Symbols
on page 233. The scanner beeps once.
For further RS485 settings, refer to RS485,page 14.
Connect EAS
Note: The 7980GEL does not support the EAS interface.
2
3
1
RS485 Connection:
2
3
1