154 Solaris 7980g User Guide
Default = Interlocked.
EAS Interlocked Duration Timeout
When using the Interlocked EAS Mode of Operation, you must set the lag time
between when a bar code is read and when the EAS tag is deactivated. Use this
selection to set this timeout (in milliseconds). After scanning the EAS Interlocked
Duration Timeout bar code, set the timeout duration (from 1-5000 milliseconds)
by scanning digits on the Programming Chart inside the back cover, then scanning
Save. Default = 100 ms, which is 0.1 second.
EAS Interlocked Duration
Timeout
To Next Page
Loading...
