Solaris 7980g User Guide 57
In this example, you are scanning PDF417, Code 128, and Code 39 bar codes, but
you want the scanner to output Code 39 first, Code 128 second, and PDF417 third.
Set up the sequence editor with the following command line:
SEQBLK sequence editor start command
62 code identifier for Code 39
9999 code length that must match for Code 39, 9999 = all
lengths
43 start character match for Code 39, 43h = "C"
FF termination string for first code
6A code identifier for Code 128
9999 code length that must match for Code 128, 9999 = all
lengths
54 start character match for Code 128, 54h = “T”
FF termination string for first code
72 code identifier for PDF417
9999 code length that must match for PDF417, 9999 = all
lengths
4D start character match for PDF417, 4Dh = “M”
FF termination string for third code
The whole command line would look like this:
SEQBLK62999943FF6A999954FF7299994DFF
The data is output as:
CODE39SMPLTSTMSGCODE128MSGPDF417
See the next example to further refine this output.
Output Sequence Example 2 - Three Symbologies with <> Separators
In this example, you are scanning the same three bar codes, but you want <> brack-
ets and a carriage return and line feed to separate your output.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
