Safety
MAN0996_Iss 1_02/16 Touchpoint Plus
Pt. No. 3011M5044_EN 11 User Guide
2.3.6 Product Compliance
This product complies with the following standards and directives.
Other safety directives may apply to the complete system installation if an OEM’s product is integrated into other
equipment or machinery.
Safety Compliance
Hazardous Location
(Non-Incendive)
Class 1, Division 2, Groups A,B,C,D, Temp. Code T4
ISA 12.12.01-2013
CSA C22.2 No. 213-M1987
Electrical Safety
CAN/CSA C22.2 No. 61010-1 and No.142
UL 61010–1 (3
rd
Edition); UL508
IEC/EN 61010–1 (3
rd
Edition)
EMC/RFI
EN 50270
Low Voltage Directive
IEC/EN 61010–1 (3
rd
Edition)
Gas Performance*
ISA 12.13.01 and CSA C22.2 No. 152
* ISA 12.13.01 and CSA C22.2 No.152 approvals are applicable only to mV sensors Model 705 and MPD or any suitably
certified mA sensor.
Note: The Equipment referred to in this manual contains components and assemblies that are each certified for use in a
variety of differing environments, and it is the site owner’s responsibility to confirm the suitability of the equipment prior to
its installation and use.
Please check the product rating plate and look for the following marks to ensure that the supplied equipment is
suitable for its intended location and purpose:
Products bearing the CE mark conform to all applicable European Directives as stated on the Honeywell product specific
EC Declaration of Conformity.
Products bearing the UL mark conform to the requirements for Ordinary Locations. The letters C and US mean that the
product is certified for use in Canada and the United States of America.
IMPORTANT
Read and understand the instruction manual before operating or servicing the equipment.
To Next Page
Loading...
Need help?
General
