Honeywell VFD CORE User Manual

CHAPTER 11: SUMMARIES OF PARAMETER SETTINGS
115 63-4528—04
07-12
Deceleration Time at
Momentary Power Down ( dEb
function: Deceleration Energy
Backup)
0: Disable
1: 1st decel. time
2: 2nd decel. time
3: 3rd decel. time
4: 4th decel. time
5: system decel. time
6: Auto decel. time
0
07-13 DEB Return Time 0.0~25.0 sec 0
07-14 Dwell Time at Accel. 0.00~600.00sec 0
07-15 Dwell Frequency at Accel. 0.00~600.00Hz 0
07-16 Dwell Time at Decel. 0.00~600.00sec 0
07-17 Dwell Frequency at Decel. 0.00~600.00Hz 0
a
07-18 Fan Cooling Control
0: Fan always ON
1: 1 minute after the VFD stops, fan will be OFF
2: When the VFD runs, the fan is ON. When the VFD stops,
the fan is OFF
3: Fan turns ON when the preliminary heat sink’s
temperature reached around 60°C (140°F).
4: Fan always OFF
0
a
07-19
Emergency Stop (EF) & Force
to Stop Selection
0: Coast stop
1: By deceleration Time 1
2: By deceleration Time 2
3: By deceleration Time 3
4: By deceleration Time 4
5: System Deceleration
6: Automatic Deceleration
0
a
07-20
Auto Energy-sAVI1ng
Operation
0: Disable
1: Enable
0
a
07-21 Energy-sAVI1ng Gain 10~1000% 100
a
07-22
Auto Voltage Regulation(AVR)
Function
0: Enable AVR
1: Disable AVR
2: Disable AVR during deceleration
0
07-23 PWM Fan Speed 0~100% 0~100 60
Table 8. Special Parameters
Parameter Explanation Settings
Factory
Setting

Honeywell VFD CORE Specifications

General

Brand	Honeywell
Model	VFD CORE
Category	Thermostat
Language	English