Honeywell VFD CORE - Page 158

CHAPTER 12: DESCRIPTION OF PARAMETER SETTINGS
63-4528—04 158
It is recommended to be used with Dwell function as shown in the following:
• It is to improve the unstable speed or unstable position due to insufficiency of analog resolution. It needs to be used with
external terminal (set to 43). After setting this parameter, it needs to adjust the analog output resolution of controller
simultaneously by this setting.
a
02 - 45 Max. Frequency of Resolution Switch
Factory Setting: 60.00
Settings 0.01~600.00Hz
a
02 - 46 Switch the delay time of Max. output frequency
Factory Setting: 0.000
Settings 0.000~65.000 seconds
M33644
TIME
OUTPUT
FREQUENCY
FREQ. COMMAND
> 02 32 AND
OUTPUT CURRENT
> 02 31
FREQ. COMMAND
< 02 32 AND
OUTPUT CURRENT
< 02 31
MULTI FUNCTION OUTPUT
MO 42 (ACTIVE WHEN
FCOM
> 02 32,
OUTPUT CURRENT
> 02 31
AND TIME
> 02 30)
02-30 02-30
M33650
OUTPUT
FREQUENCY
MULTI-FUNCTION
OUTPUT MO 42
(ACTIVATE WHEN
FCMD
> 02-32
OUTPUT CURRENT
> 02-31
TIME
> 02- 30)
SET 07- 15 02 -32 &
OUTPUT CURRENT > 02-31
SET 07- 17 02 -32 &
OUTPUT CURRENT < 02-31
07- 17
DWELL
FREQ. AT
DECEL.
07- 15
DWELL
FREQ.
AT
ACCEL.
07- 16
DWELL
TIME
AT
DECEL.
07- 14
DWELL
TIME
AT
ACCEL.
02- 30
BRAKE
DELAY TIME
02- 30
BRAKE
DELAY TIME
M33651
RESOLUTION
SWITCH
MI 43
AUI + 10 V
AUI – 10 V
FORWARD RUNNING
REVERSE RUNNING
ON
MAX. OUTPUT
FREQ. 01-00
RESOLUTION SWITCH
FREQ. 02-45
MAX. OUTPUT
FREQ. 01-00
ACCEL. / DECEL. TIME
01-12 ~ 10-19
DELAY
TIME FOR
MAX.
FREQ.
SWITCH
02-46
DELAY TIME
FOR
MAX. FREQ.
SWITCH 02-46
OUTPUT
FREQUENCY
AUI + 0 V
FREQUENCY
COMMAND
0Hz