Honeywell VFD CORE

CHAPTER 12: DESCRIPTION OF PARAMETER SETTINGS
187 63-4528—04
• OPHL: Output Phase Loss
• Over ripple protect
06 - 39 Treatment for Output Phase Loss Detection (OPHL)
Factory Setting: 2
Settings 0: Warn and keep operating
1: Warn and ramp to stop
2: Warn and coast to stop
3: No warning
06 - 40 Deceleration Time of Output Phase Loss
Factory Setting: 0.500
Settings 0.000~65.535 seconds
06 - 41 Current Bandwidth
Factory Setting: 1.00
Settings 0.00~655.35%
06 - 42 DC Brake Time of Output Phase Loss
Factory Setting: 0.100
Settings 0.000~65.535 seconds
06 - 43 Time for Input Phase Loss Detection
Factory Setting: 0.20
Settings 0.00~600.00 seconds
06 – 44 Ripple of Input Phase Loss
Factory Setting: 30.0 / 60.0
Settings 230V models: 0.0~160.0 Vdc
460V models 0.0~320.0 Vdc
06 - 45 Treatment for the detected Input Phase Loss (OrP)
Factory Setting: 1
Settings 0: warn, ramp to stop
1: warn, coast to stop