CHAPTER 12: DESCRIPTION OF PARAMETER SETTINGS
63-4528—04 226
• This parameter needs to co-work with Pr09-48.
• Setting 0: The baud rate can only be set to 0, 1, 2 or 3.?
• Setting 1: Setting of DeviceNet baud rate can be the same as CANopen (setting 0-8
• Setting 0: it needs to set IP address manually.
09 - 46 Error Code
Factory Setting: ##
Settings Read Only
09 - 47 Address of Communication Card
Factory Setting: ##
Settings DeviceNet: 0-63
Profibus-DP: 1-125
09 - 48 Setting of DeviceNet Speed (according to Pr.09-49
Factory Setting: 2
Settings Standard DeviceNet:
0: 100Kbps
1: 125Kbps
2: 250Kbps
3: 1Mbps
Non standard DeviceNet:
0: 10Kbps
1: 20Kbps
2: 50Kbps
3: 100Kbps
4: 125Kbps
5: 250Kbps
6: 500Kbps
7: 800Kbps
8: 1Mbps
09 - 49 Other setting of Device net Speed
Factory Setting: 1
Settings 0: Disable
1: Enable
09 - 50 IP Configuration of the Communication Card
Factory Setting: 0
Settings 0: Static IP
1: Dynamic IP (DHCP)
To Next Page
Loading...
Need help?
General
