HP 1650B

BASE
BASE
command
The BASE command sets the base in which symbols for the specified label
will be displayed in the symbol menu. It also specifies the base in which
the symbol offsets are displayed when symbols are used.
p’
Note !b
BINary is not available for labels with more than 20 bits assigned. In this
case the base will default to HEXadecimaI.
Command Syntax:
:MACHine{ 112):SYMBol:BASE c label-name >, c base-value >
where:
c label name >
:: = string of up to 6 alphanumeric characters
c base value >
:: = {BINary ) HEXadecimal 1 OCTal ) DECimal 1 ASCii)
Example:
OUTPUT XXX;“:MACHINEl:SYMBOL:BASE ‘OATA’,HEXADECIMAL”
SYMBol Subsystem
20-4
HP 1650B/HP 16518
Programming Reference